***froggi***

amyinaustin

what did you end up doing for your pg skeleton shirt?  I remember that the bones had started coming off?  We just washed ours this weekend (after only wearing them once for halloween) and mine is fine, DH's (w/ beer in the belly) got all funky.  I'd love to know if you have a solution!

TIA!

Mrs.Froggianna

I got more of the ultra heat bond stuff that Nanann suggested and ironed them back down.  Although I noticed about 1/3 of the way through that if I just re-ironed some of the parts the old bond-adhesive stuff sorta "reactivated" and the bones stuck without adding more bonding.  That worked for most of the bones, but a few I had to go back and add more of the bonding stuff.  Good luck!  I hope you can fix your shirt!

amyinaustin

hmm, okay but how did you get just the right tracing for each little piece?  I'd want to make sure that it adheres well to the shirt all the way to the edges of the bone pieces to prevent it from happening again, right?

Mrs.Froggianna

I'd get the sheet version (not the strip, which is what I got) and trace the piece you need onto the sheet.  Cut it out and iron as best you can.  Honestly I haven't a crafty bone in my body so I may not be the best person to give advice on this. 

amyinaustin

no, that totally makes sense- so you lay it over the piece that is coming off and trace around it.  Got it - thanks!