where did you get a board for the angelcare monitor

mela-sha · July 2010

and how much did it cost?

thanks!

StrawberryAlarmClock · July 2010

DH had some extra Masonite from building his skateboard ramp so he used that. Works great. A couple bucks for a HUGE sheet at Lowe's.

Mrs.BoomBoom · July 2010

StrawberryAlarmClock:
DH had some extra Masonite from building his skateboard ramp so he used that. Works great. A couple bucks for a HUGE sheet at Lowe's.

And if you bring in your measurements, Lowes/Home Depot will rip it down to size for you

tarapaige1 · July 2010

We use a thick, foam posterboard. Works just fine

hrw_aggie03 · July 2010

Why do you need a board?

JoJoLiz6 · July 2010

We got our board from Home Depot. My DH cut it to size. You need a board so the sensor sits on a stable surface. My crib has the wire slats on the bottom and the sensor wouldn't work properly sitting on the wire.

buckeyeki · July 2010

They have boards that fit inside a standard crib at Home Depot or Lowe's. We got ours at HD - its was like $5ish. We didn't cut it down to the exact size, but it works great. I think the size they mention in the instructions is the minimum you need.

Also, I have a piece of cardboard I use with it for the pack n play for when we travel and that works well too. I wouldn't recommend using cardboard for everyday use, but in a pinch it does work.